Model TD-SB-WC-BC-D10-L10-T2 has a 10 mm bulb diameter, a 10 mm tail length and a thickness field of 2 mm. The single-bulb tadpole gasket has an outer surface of intertwined fiberglass yarns forming a rounded tube. For an oven or stove door, compare that rounded bulb and its tail with the actual door-frame profile before choosing the attachment arrangement.
The bulb and tail provide two distinct features to locate on a drawing: the rounded part is the profile presented at the intended contact path, while the tail provides a flat extension to consider in the mounting layout. The dimensions above identify the named model; they do not prescribe how far a finished door must compress it.
Read the profile before selecting an attachment
The single-bulb tadpole gasket has a stainless-steel-wire supporting tube inside its core. This core sits within the rounded fiberglass-yarn profile. When a buyer compares a cross-section with a frame drawing, identifying that bulb and its support avoids confusing the gasket with a flat tape or a double-bulb profile.
The captured double-bulb alternative has two adjacent cores, while the single-bulb model has one rounded bulb. Check which footprint the frame drawing calls for before comparing dimensions; the two profiles should not be treated as interchangeable.
The gasket supplies the textile profile and internal support. The buyer provides the mating door and frame geometry, the intended contact path and the mounting surface. Mark those features on a cross-section so the bulb and tail are considered in their actual positions.
Compare the named model with the frame
Use the 10 mm bulb diameter and 10 mm tail length as separate reference dimensions for this model. The 2 mm value is a thickness field; it is not a specified compression requirement. Compare the available bulb space and tail footprint with the measured frame, including corners or changes in the mounting path.
| Profile input | Buyer review |
|---|---|
| Bulb diameter | Compare with the intended contact space and door geometry |
| Tail length | Compare with the available mounting footprint |
| Thickness field | Retain the labelled value and clarify its application in the drawing review |
| Frame path | Identify corners, joints and locations where the profile changes direction |
If the named geometry is not a useful match, send the cross-section and required contact path to discuss a customised size or configuration. Avoid selecting a profile solely from the outside appearance of an existing seal.
Review the optional attachment
Self-adhesive tape is available as an installation option for the single-bulb tadpole gasket. Treat it as an option to discuss, rather than assuming it is included in every configuration. The mounting surface, preparation, installation procedure and operating duty all belong in the attachment review.
A representative sample and frame drawing can make the discussion concrete: check the tail’s footprint, the placement of the bulb and the intended joint or corner arrangement. Apply the equipment maker’s own criteria to the assembled door. A profile measurement by itself does not establish a leakage result or service life.
Product and Specification Reference
The dimensions above refer to model TD-SB-WC-BC-D10-L10-T2 on Bonsing’s public single-bulb product page, reviewed in October 2026. Confirm the selected configuration, attachment and project conditions during technical review or quotation.
FAQ
Does the 2 mm field specify gasket compression?
No. It is the thickness field for the named model. Define the door geometry and required acceptance conditions separately.
Is self-adhesive tape included with every gasket?
It is an available installation option. Discuss the requested configuration and its suitability for the actual mounting surface and duty.
Can a different bulb or tail size be discussed?
Yes. Provide the frame cross-section and required profile dimensions to discuss a customised configuration.
Discuss a Door-Gasket Profile
Review the single-bulb tadpole gasket. Share the frame drawing, bulb space, tail footprint, mounting surface and operating duty. Discuss a door-gasket profile with Bonsing or request a customised configuration review.
Post time: Nov-12-2026