News

PET025 Sleeve for Sensor Cable Chafe Points

SPANDOFLEX PET025 is made from 0.25 mm polyethylene terephthalate monofilament. It is a braided mechanical covering that can be considered where a sensor cable or harness contacts another part of an assembly. The first design task is to locate that contact, not merely to specify a sleeve somewhere along the cable.

SPANDOFLEX PET025 has a size range of 3 mm to 50 mm. Use that offered range to begin a candidate discussion, then assess the actual harness, fittings and route. The 0.25 mm value is the monofilament diameter; it is not the sleeve wall thickness or the cable diameter.

Identify the sleeve and the protected assembly

Black and orange braided sleeve lengths
The open braided PET025 product form is shown.

SPANDOFLEX PET025 is a flexible protective sleeve for pipes and wire harnesses. SPANDOFLEX PET025 is offered for sensor assemblies as well as wire harnesses, pipes and hoses. The braid is the mechanical covering; the sensor, cable, brackets and acceptance criteria belong to the buyer’s assembly.

Flexibility makes the sleeve relevant to a routed cable, while the open textile form lets the engineer identify the material surrounding the line. The decision is where that covering should sit and how the actual routed assembly will be assessed, not whether one sleeve size automatically fits every connector or branch.

Map contact points along the sensor cable

Illustrative sensor cable near a metal bracket
Illustrative cable and bracket review; no company sleeve or test is shown.

Follow the cable from the sensor to the harness and note where it approaches a bracket, panel edge, clamp or neighboring component. Identify any location that changes during the equipment’s intended movement. Mark each contact zone and the length over which the cable needs a mechanical covering.

Record on the drawing Decision supported
Sensor, connector and cable route Identifies the assembly and access points
Contacting surface and location Defines the part of the cable to review
Movement and operating positions Describes how the contact changes in use
Sleeve start and end Connects the selected covering to the contact zone
Acceptance method Defines the buyer’s evaluation of the completed assembly

Place the covering without hiding the route

Compare the intended sleeve segment with branches and the sensor connection. A covering that ends before the contact point does not answer the original placement question. Conversely, an unnecessarily broad segment can make access to a connector or inspection point harder to assess. Mark start and end positions on a representative harness and review them with the assembly team.

The product’s stated size range is useful for identifying candidate sizes. It is not a formula for the installed diameter or a guarantee that a selected sleeve will pass a particular fitting. If the route, access or size requirement differs from the available candidate, share the drawing to discuss a customised configuration or solution.

Assess the representative harness

Use the buyer’s applicable procedure to evaluate the actual contact surface, movement and completed harness. Record the sleeve configuration, cable route, contact locations and conditions alongside the result. The presence of a braid or a product photograph does not establish a quantified abrasion result or service life.

Product and Specification Reference

The 0.25 mm monofilament and 3–50 mm size range refer to the SPANDOFLEX PET025 product page reviewed in November 2026. Confirm the selected size and configuration for the requested assembly during technical review or quotation.

FAQ

Is 0.25 mm the PET025 sleeve wall thickness?

No. It is the diameter of the PET monofilament used in this model. Confirm the required sleeve dimensions for the actual assembly separately.

Does the 3–50 mm range guarantee fit over my sensor connector?

No. It is the stated product size range. Compare the selected configuration with the real cable, connector and installation route.

What should a chafe-point enquiry include?

Provide the sensor harness drawing, contact locations, movement, proposed coverage and the buyer’s acceptance method.

Discuss Sensor Harness Protection

Review the SPANDOFLEX PET025 sleeve. Share the sensor cable route, contact surfaces, movement, desired covering length and evaluation method. Discuss sensor harness protection with Bonsing or request a customised configuration review.


Post time: Nov-19-2026

Main applications