News

Self-Closing Sleeve for Pre-Terminated Harnesses

SPANDOFLEX SC is a self-closing protective sleeve made from PET monofilaments and multifilaments. Its wraparound construction lets an assembly team consider adding a mechanical covering after wires or tubes have already been terminated, rather than relying on access through the end of the harness.

SPANDOFLEX SC has a stated size range of 6 mm to 50 mm. Use that range to start a configuration discussion, then review the actual harness envelope, branches and the room available to open and close the sleeve along the intended route.

Place the sleeve after termination

Black and purple self-closing sleeve lengths
The sleeve is a wraparound covering for a terminated harness.

SPANDOFLEX SC can be installed on pre-terminated wires or tubes after assembly. This changes the production question: instead of deciding only whether a connector can pass through a closed tube, the team can examine whether it can reach the selected section from the side.

The sleeve supplies the PET wraparound covering. The buyer provides the terminated wires or tubes, connectors, branch layout and production sequence. Mark the part of the harness that needs coverage and confirm that the assembly team can reach it throughout that length.

Plan access around branches

Illustrative branched harness with fitted connectors
A generic terminated harness illustrates the branches and connector access to review.

A sensor harness may have a main run, a short branch and connectors already fitted at its ends. Mark each breakout before selecting the covered segment. Review where the sleeve begins and ends relative to a branch and whether nearby clips or equipment obstruct side access. The self-closing concept supports a later assembly step; the actual fit still depends on the specific harness and selected sleeve.

Production question Review on the representative harness
Is the harness already terminated? Identify connectors and access to the covered section
Where do sensor branches leave the main run? Mark breakouts and the intended sleeve limits
What is the local bundle envelope? Compare the actual section with the candidate size
Can the sleeve be reached along the route? Check adjacent clamps, equipment and working room

If the requested route or bundle is outside the candidate arrangement, send the drawing and access constraints to discuss a customised configuration or solution. The 6–50 mm family scope is a starting reference, not a guarantee of fit for a particular harness.

Reopen for the next service task

The self-closing sleeve opens as a wraparound for maintenance or inspection. Plan where a technician needs access and whether nearby components permit the sleeve to be opened and returned to position. Record the locations on the assembly plan so the later service question is considered before the final route is fixed.

This is a mechanical covering, not a stated liquid seal or electrical shield. Any separate environmental or electrical requirement belongs in the assembly evaluation and the configuration discussion.

Verify the production handoff

Compare a representative sleeve with the terminated harness in the intended assembly sequence. Review the bundle envelope, connector and branch positions, accessible length and the buyer’s acceptance criteria. Retain the candidate identity and harness revision with the result so later routing changes can be reviewed against the same task.

FAQ

Can SPANDOFLEX SC be installed after wires are terminated?

Yes. Its self-closing construction is intended for installation on pre-terminated wires or tubes after assembly. Check actual access and fit on the harness.

Does the 6–50 mm range guarantee fit around every connector?

No. It is the stated size range. Review the chosen configuration, harness envelope, connector and side access together.

Can the wraparound be opened for inspection?

Yes. The sleeve can open for maintenance or inspection; plan access around the actual route and adjacent components.

Discuss an SC Sleeve Layout

Review the SPANDOFLEX self-closing sleeve. Share the terminated harness drawing, bundle dimensions, branch locations, intended coverage and assembly sequence. Discuss an SC sleeve layout with Bonsing or request a customised configuration review.


Post time: Nov-20-2026

Main applications